Q4 (3) 03) Given | unit of’N-PN BJT transistor with the. power rating of 2 W, ue = 100 and r ‘c – an and Van = DEV for fowvard biasing. Design a…

This figure from Klironomos et al. 2005 shows an experiment done over 6 years. They looked at AMF (mycorrhiza) species richness in ambient CO2 and…
September 17, 2020
Week 4 Discussion questions “Breakeven Point”
September 17, 2020

hi i have this questions

(1) given 1 unit of NPN BJT transistor with the power rating of 2W,Bdc=100 and r’e=2ohm and Vbe=0.7v for foward biasing.

(a)Design a simple power amplifier using common emitter configuration driven by +20V DC supply to achieve Q point at the centre of DC and AC load line and with the maximum efficiency .Consider a load of Rl =100ohm in your design.Show your calculation and sketch the schematic diagram.You may refer to appendix for the commercial value of resistor.

(b) calculate the power gainAp and maximum load power Pl

Thanks for installing the Bottom of every post plugin by Corey Salzano. Contact me if you need custom WordPress plugins or website design.

The post Q4 (3) 03) Given | unit of’N-PN BJT transistor with the. power rating of 2 W, ue = 100 and r ‘c – an and Van = DEV for fowvard biasing. Design a… first appeared on Submit Your Homeworks.


Q4 (3) 03) Given | unit of’N-PN BJT transistor with the. power rating of 2 W, ue = 100 and r ‘c – an and Van = DEV for fowvard biasing. Design a… was first posted on September 17, 2020 at 11:29 am.
©2019 "Submit Your Assignment". Use of this feed is for personal non-commercial use only. If you are not reading this article in your feed reader, then the site is guilty of copyright infringement. Please contact me at support@lawwriters.org

 

"Are you looking for this answer? We can Help click Order Now"

Law Writers